CrystalLink USB 3.0 2-Port USB 3.0100m Multimode Fiber Optic ExtenderInstallation and User Manual
9 b. Expand “USB settings” c. Expand “USB selective suspend setting” 3. Select “Disabled”. OS X To disable “suspen
10 2. For both Battery and Power Adapter power settings, move slider bar to “Never” for “Computer Sleep”. 3. In the popup warning window, click
Connecting a USB 3.0 Device 1. Install any software required to operate the USB device(s). Refer to the documentation for the USB device(s), as req
Checking the Installation 1. On the Transmitter and Receiver units, check that the Power, Status, and Host LEDs are on and solid. If the Host or St
13 Troubleshooting The following table provides troubleshooting tips. The topics are arranged in the order in which they should be executed in most
14 PROBLEM CAUSE SOLUTION Host LED on TRANSMITTER/ RECEIVER units are off. • The host computer is not powered on. • The TRANSMITTER unit is not conn
15 All LEDs on both the TRANSMITTER unit and RECEIVER unit are on but the USB device does not operate correctly, or is detected as an “Unknown Devi
16 Contacting Technical Support If you are experiencing problems not referenced in the Troubleshooting section, you may contact Rose Electronics Te
17 Technical Glossary USB Connectors USB cables have two classes of connectors. The Type A connectors are used to connect the cable from a USB dev
18 Specifications Operating Distance Up to 100m (330 ft) USB Device Support & Throughputs USB 3.0 up to 5Gbps USB Host Support xHCI controlle
FCC Radio Frequency Interference Statement Warning This device complies with Part 15 of the FCC rules. Operation is subject to the following two c
Contents Introduction ... 3 Product Content
4 Introduction This document provides product information for the CrystalLink USB3.0, installation instructions, troubleshooting guidelines, and ins
5 Rear View ITEM TYPE DESCRIPTION 1 Power ON Unit is powered properly. Power OFF Unit is not powered or not powered properly. 2 Status
6 Front View Rear View The RECEIVER Unit The Receiver unit has two USB Type A ports for USB 3.0 devices. The RECEIVER unit allows you to connect u
7 Installation Guide Example Application USB 3.0 Camera Computer & MonitorUSB 3.0 up to 100m over multimode fiber TRANSMITTER RECEIVER Assemb
8 Installing the CrystalLink USB3.0 System Preparing Your Site Before you can install the CrystalLink USB3.0, you need to prepare your site: 1
a. Click on Change Plan Setting 2. Select “Never” for “Put the computer to sleep” for all the configurations
Comments to this Manuals