Rose electronics MultiStation Instruction Manual download pdf (Page 20)

OPERATION

MULTISTATION INSTALLATION AND OPERATIONS MANUAL

Dip Switch Settings

The front panel dip switch enables or disables commands from each KVM

station. To enable commands from a KVM station put the corresponding dip

switch in the up position. To disable commands, put the switch in the down

position. The dip switch on the right controls KVM #1, the next switch controls

KVM #2, and so on. The below table shows the dip switch configuration and

each settings function.

DIP SWITCH CONFIGURATION / DESCRIPTION

Up – enable commands Down – disable commands

Switch location

Model ML-2U

Model MK-4U

Model MLK-2U

KVM 1

Local unit

KVM 2

Remote unit

No effect

KVM 3

No effect

KVM 4

No effect

1 - 4

No effect

Example shown enables KVM 1 and KVM 3 and disables KVM 2 and KVM 4

Table 7. Dip Switch Settings

1 2 3 4 5 6 7 8

IMPORTANT OPERATION NOTES:

1. To issue any keyboard command, first press and release the

right control key (Ctrl) then within 2 seconds issue the

command or it is aborted.

2. Use only the numeric keys above the keyboard for entering

numeric commands. Numeric keypad entries are not

recognized. All numeric commands must use the [Enter] key to

complete the command.

3. Keyboard commands are not case sensitive and are shown

capitalized for clarity only. DO NOT USE THE SHIFT KEY

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

No comments

Rose electronics MultiStation Instruction Manual Page 20