Rose electronics ORION LC Instruction Manual download pdf (Page 13)

OPERATION

ORION EXTENDER INSTALLATION AND OPERATIONS MANUAL

Operating instructions – Local KVM access

Operation of your computer is no different than having your keyboard,

monitor, and mouse connected directly to the computer. All functions,

applications, upgrades and other items can be done normally. The only

difference is the computer can be up to 450 feet away (33,000ft over fiber).

Orion Extender DVI with local KVM access allows an additional KVM station

to be connected to the transmitter. The CPU can easily be operated from the

remote KVM station or the local KVM station but not simultaneously.

The transmitter or local unit is active during boot-up and the connected CPUs

video is displayed on both the local and remote KVM stations monitor. To

activate the remote KVM station, simply press any key on the remote KVM

stations keyboard. Control is passed to the remote KVM station. To activate

the local KVM station, press any key on the KVM station’s keyboard.

The dual video models have the capability of connecting the transmitter to two

video sources. The two video sources are sent to the receiver and displayed

on its two video monitors. Video source one should be connected to the

computer’s primary DVI video port that is associated with the keyboard and

mouse.

REFER TO THE ORION LC USERS MANUAL FOR COMPLETE

INSTALLATION AND OPERATION PROCEDURES.

DDC Information

By default, the Orion Extender uses its own internal DDC table. In some

configurations it may be necessary to redefine the source of the DDC

information. The Orion Extender can use the internal DDC table, the DDC

information from the local video, or download the DDC information from the

remote video monitor. To modify the source of the DDC information, perform

the following internal adjustments to the local unit. Adjustments are made on

the local unit to use the default DDC information, the LOCAL monitor’s DDC

information, or the REMOTE monitor’s DDC information.

A- Carefully remove the four (4) Phillips screws from the bottom of the

unit. If your model is a dual version, also remove the UNC screws that

secure the video connectors.

B- Remove the top cover exposing the internal PC board as shown

below

CAT5 Connector

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

No comments

Rose electronics ORION LC Instruction Manual Page 13