Rose electronics MultiVideo Instruction Manual download pdf (Page 40)

OPERATION

ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL

Selecting a computer

To connect to a computer, you can select it from the UltraView Pro’s front

panel, select it by keyboard commands, select it through the RS232 serial

port, or you can select the computer from a computer select window as

shown in Figure 15.

Selecting a computer from the front panel

Using the + and – buttons on the front panel will advance (+) or switch to

the previous (-) computer port.

Selecting a computer using keyboard commands

Press and release the left control <Ctrl> key, then enter the computer port

number. Pressing and releasing the left control <Ctrl> key then the “+” or “–

“ key will advance forward or backwards one sequential port.

Selecting a computer through the RS232 port

Selecting a computer can be done through the RS232 port if needed.

Contact Rose Electronics Technical support for details.

Selecting a computer using the Computer select window

Press and release the left control <Ctrl> key, then press Esc. The

computer select window will display. Use the up/down arrow keys and

select the computer to switch to and press enter. You will be immediately

connected to that computer. Use the page up/down keys if there are more

than 16 computers in your system.

Figure 15. Computer select window

Computer select window

1→

2 Computer 2

3 Computer 3

4 Computer 4

5 Computer 5

6 Computer 6

7 Ct 7

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

No comments

Rose electronics MultiVideo Instruction Manual Page 40