Rose electronics MultiVideo Instruction Manual download pdf (Page 43)

ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL

Keyboard command usage

When using keyboard commands to enter information to the UltraView Pro,

please observe the following guidelines to avoid entering incorrect values or

no values.

1. All commands start with a press and release of the left control key.

2. Commands following the press and release of the left control key must

be entered within 2 seconds or control reverts to the connected

computer and the command will be sent to that computer and not the

UltraView Pro.

3. Use only the numeric keys above the keyboard and not the numeric

keypad.

4. Letter commands such as <Ctrl> L are not case sensitive and are only

shown in uppercase for clarity. Do not use the shift key to enter letter

commands.

5. To connect to the next or previous computer, the keyboard command

is <Ctrl> + or <Ctrl> -. The plus and minus keys on the keypad will

connect to the next or previous computer. The + and – keys on the

keyboard, next to the backspace key vary from country to country as to

their usage. These keys can still be used to connect to the next or

previous computer.

Reset to factory defaults

To reset the UltraView Pro to the original factory default settings, first,

power down the unit, press and hold the – (minus) switch in and turn the

power on to the unit. Keep the – (minus) switch held in until the unit

switches to the last port on the unit (port 4, 8, or 16). If you release the –

(minus) switch before the last port is switched to, the defaults will not be

restored. The configuration and access passwords are not reset using this

procedure.

Rackmounting

The UltraView Pro can be rack mounted using a Rose Electronics

Rackmount kit. See Appendix D and E for instructions.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

No comments

Rose electronics MultiVideo Instruction Manual Page 43