Rose electronics Translator Instruction Manual download pdf (Page 16)

SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL

When all needed CPU ports have been pre-configured, the computers can

be connected. Perform the following for each computer to be connected:

(Refer to the Troubleshooting section if needed and Figure 3 for a example

of a single unit installation)

Steps

1. Turn on the KVM stations monitor and apply power to the ServeView

Pro.

2. Wait until the “SELECT 1” LED on the front panel lights.

3. Switch the ServeView Pro to CPU port x. (Ctrl,port #,[Enter])

(Starting with x = 1)

4. Connect the computer that has been pre-determined to be connected to

the CPU port being configured using the appropriate CPU cable.

5. Boot the computer, if needed. You should see the boot-up sequence on

the KVM monitor. If the computer was connected to a pre-configured

CPU port with power applied, you should see that computers video.

6. Switch to the next CPU port to connect a computer to as defined in step

3 and perform steps 4 and 5 for this computer and for then for the

remaining CPU ports.

4 CPUs can connect to a 4-port model,

8 CPUs to an 8-port model,

16 CPUs to a 16-port model)

Figure 3. Single Unit installation

CPU-2 CPU-1

CPUs 3-8 KVM-1 Station

ServeView Pro

CPU cable KVM cable

CPU cable CPU cable

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Rose electronics Translator Instruction Manual Page 16